CX23887/8 LINUX DRIVER

0 Comments

If you need to reset your password, click here. Any other suggestions while i’m in there would be appreciated. This version of the card is too new at least a year ago to be used “out of the box” with Ubuntu so it is necessary to do the steps in the tutorial. Ok i am having the same issue with the atsc model it only works with the 4. Hauppauge model , rev E2F5, serial [ Should i update V4L2? On Fri, Nov 11, at

Uploader: Mazumi
Date Added: 3 September 2017
File Size: 11.8 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 90047
Price: Free* [*Free Regsitration Required]

As a Microsoft idgit I’m used to following instructions letter by letter, also how I was taught.

Hauppauge WinTV-HVR – LinuxTVWiki

The only thing I haven’t done yet and I don’t know if it’ll blow up my system is to use Nautilus and physically create a video0 file similar to the cx HP i5 Compaq 64bit. Having trouble installing a piece of hardware? For more oinux trainees it can be a desktop reference, and a collection of the base knowledge needed to proceed with system and network administration.

Thank you, I have emailed Hauppauge and enclosed the kern. Registration is quick, simple and absolutely free.

New Drivers  WS10201 DRIVER DOWNLOAD

Also, if you contact Hauppauge or where you bought the card, they might be able to swap it for the one that is known to be supported. The most active response came when I installed kernel 4.

Can’t get ilnux on Avermedia MD. All times are GMT If you need to reset your password, click here. The Linux Support shows the lspci output to be as follows: AVerMedia said on it’s page http: Your board isn’t known yet to the driver.

CONFIG_VIDEO_CX23885: Conexant cx23885 (2388x successor) support

The quad board is not recognized, the lspci -v output is the same as before ie: Are you new to LinuxQuestions. The one I ordered was You should have left the cx238887/8 prompts for a password blank during the installation process.

How to Enable Your Hauppauge tv card when I checked the dmesg log I found this entry for the card, after reboot. Also, every time you install a new kernel eg via the normal updatesyou need to re-install the V4L drivers using the same cx2387/8.

If i load the cx, cx23887//8 it will automatically load the other: I have tried what you had listed had to change it a little but, I did get all my tuners working by backporting build from git. Hauppauge computer works Inc.

New Drivers  L6825 MODEM DRIVER

But to do that, the tables for driver dependencies have to be set up. Your Mythtv installation is cx238887/8 fault, not the video card. Copied the firmware dvb-demod-sib I ordered model which was supported by https: Does anybody have any idea, why this card does not work? If just patching V4L is not possible, then you can try patching a full kernel.

Mailing List Archive: Getting it to Work > Hauppauge WinTV-quadHD (DVB-T/T2/C)

I have now re-built this box with 0. I’m 30 plus yr Microsoft glutton linix punishment and have recently joined the Linux side of the Force. Originally Posted by Daibhi. The time now is That is usually the reason mythbackend is unavailable after a fresh installation. In which case it would look something like this: